Welcome to the United Manufacturing Hub Stack installation guide. In this guide, we will walk you through the process of installing the stack on an edge device. This process is divided into three parts: first, the installation of Flatcar, followed by the setup of the stack within UMHLens. Please note that while the accompanying videos may be helpful, some of the information may be outdated. Refer to the text on this page as well as the description of the youtube videos to verify if the information is still up to date. Make sure you have the necessary hardware and prerequisites before beginning the installation.
<aside> 💡 If you encounter any issues, feel free to check out the troubleshooting section at the bottom of this article
</aside>
minimal:
recommended:
Depending on your situation you might want to deviate from the guide to do some adjustment but for your first installation it is recommended that you stick to it!
As you can see in the illustration, there are some prerequisites for the installation.
<aside> 💡 You can leave out the computer screen, keyboard, network, etc. if you install it on a virtual machine. Some of the instructions might then be a little bit different. Please just make sure that you use the correct USB image then (see below)
</aside>